. Supports wide range of SD cards listed in AN1003. Supports auto-triggering of files on SD cards. Operates on wide range of voltages from 3.3V-5.0V DC. PICtail? and PICtail? Plus connection interfaces. Compatible with many boards with PICtail? and PICtail? Plus interfaces, including Explorer 16 Development Board, various PICDEM?boards, I/O Expansion Board, and Multimedia Expansion board. 入门指南：
To get started, a compatible MCU development board is required. In general, a board is compatible if it has a PICtail? or PICtail? Plus interface expansion port. Most PICDEM demonstration board do not have the female header installed, so if using a PICDEM board, a 14x2 female connector is included with this kit for the user to install onto the development board if necessary. When connecting to the two boards together, pay close attention to the orientation of the connector and pin alignment.开发板配置：
A total of 7 jumper locations are available. As shipped from the factory, some of the jumper locations are bridged by circuit traces forming a default setup. To change this, the user will need to cut the traces and install pins and a block jumper. Afterward, the features can be enabled or disabled easily by installing or removing the jumper.
下载连接: PICtail SD&MMC开发板简介
#板卡评测
647 人阅读
|
0 人回复
|
2012-08-16
/3 
