SMARTFUSION2入门套件

GY@艳

SMARTFUSION2入门套件包含有smartfusion2系统芯片（SOC）的FPGA方便了设计师的访问。Microsemi's SmartFusion2 Starter Kit provides designers with access to SmartFusion2 system-on-chip(SoC) FPGAs, which integrate inherently reliable flash-based FPGA fabric, a 166 MHz ARM Cortex-M3 processor, advanced security processing accelerators, DSP blocks, SRAM, eNVM and industry required high-performance communication interfaces all on a single chip.The SmartFusion2 starter kit supports industry-standard interfaces including Ethernet, USB, SPI, I2C and UART and includes a comprehensive breadboard to support unique design requirements. The kit can be used with Microsemi's Libero SoC v11.0 software, which includes a free Libero Gold license and comes preloaded with a uClinux demo. Emcraft Systems' Linux-based development environment is also supported. The SmartFusion2 device is available on an Emcraft Systems miniature (34mm x 59mm) mezzanine form factor system-on-module (M2S-SOM), which connects to the SOM-BSB-EXT baseboard. The kit is USB powered and includes FlashPro4 programming.Hardware Feature Overview

       

• SmartFusion2 SoC FPGA in the FG896 package (M2S050T-FG896ES)       
  
• JTAG interface, for programming of the SmartFusion2 device       
  
• 10/100 Ethernet interface and RJ-45 connector       
  
• USB OTG interface and mini-USB connector       
  
• USB based Wi-Fi Module       
  
• 64MB LPDDR, 16MB SPI flash       
  
• User push-button connected to GPIO on the SOM       
  
• Two user-controlled LEDs connected to GPIO on the SOM       
  
• Breadboard area available for GPIO or FPGA I/O connection       
  
• Power good LED indicating presence of the +3.3 V SOM power       
  
• Reset push button, Reset-out LED       
  
• On-module clocks       
  
• Watchdog Timer (WDT)       
  
• Serial console interface at UART CMOS levels       
  
• Low power mode with fast wake-up times       
  
• Depending on the design, can provide necessary power supply voltages (+5 V, +3.3 V, +1.5 V for power-optimized SOM operation) from external sources through dedicated pads on the breadboard.