CR95HF演示板

ladou

CR95HF演示板用于评估ST CR95HF 13.56 MHz多接触式收发器的性能，它包括一个使用USB接口与CR95HF 主机演示软件连接的电路板。The DEMO-CR95HF-A is powered through the USB bus and no external power supply is required. It includes a CR95HF contactless transceiver, a 47 x 34 mm 13.56 MHz inductive etched antenna and its associated tuning components.By default, the CR95HF communicates with the STM32F103CB 32-bit MCU via the SPI bus. The interface can then be changed to UART.At the end of the initialization, the DEMO-CR95HF-A launches a tag tracking operation. When an RFID or NFC tag is identified, the LED is turned on.
Key?Features

       

• Ready to use printed circuit board
  
         
  
  • CR95HF cut 1.2 multiprotocol transceiver IC
    
  
  
         
  
  • STM32F103CB 32-bit microcontroller
    
  
  
         
  
  • 47 x 34 mm 13.56 MHz inductive etched antenna and tuning components
    
  
  
         
  
  • USB-B connector for communication with host PC and demonstration board powering
    
  
  
         
  
  • USB connect/disconnect jumper (must be left in default state)
    
  
  
         
  
  • LED indicating the presence of an RFID or NFC tag
    
  
  
         
  
  • Microcontroller reset button
    
  
  
         
  
  • JTAG connector for microcontroller firmware upgrade and debug
    
         
  
• USB cable       
  
• Demonstration tags
  
         
  
  • ISO15693 tag: LRI2K mounted on a 45 x 75 mm antenna
    
  
  
         
  
  • ISO 15693 dual interface EEPROM memory: M24LR64-R mounted on a 15 x 15 mm double side etched antenna
    
         
  
• Associated Firmware and PC software
  
         
  
  • On-board demonstration firmware to communicate with the host PC through the USB bus.
    
  
  
         
  
  • The CR95HF developement software enable discovery and useof all the functionalities of the CR95HF transceiver.
    
  
  
         
  
  • The M24LRXX application software is dedicated to the Dual interface EEPROM and ISO/IEC 15693 contactless tag.