MCF51QE128 评估板

weiweizsz_30000

EVBQE128 评估板用于评估、演示和调试飞思卡尔 ?Flexis QE128 微控制器MC9S08QE128和 MCF51QE128。The EVBQE128 can be used as a standalone application or can be controlled by a host PC via its built-in microDART? interface.
Features


1. An “MCU” section containing:

       

• An 80-pin LQFP socket accepting either the MC9S08QE128 or the MCF51QE128 microcontroller       
  
• A crystal oscillator, a provision for a clock module, a provision for a connector for providing an external clock source, together with jumpers to select the clock source       
  
• A BDM connector for in-circuit debugging/programming with an external instrument       
  
• A female header connectors with all of the MCU signals
  

2. A power supply section containing:

       

• A 12 V DC barrel input connector (2.1 mm)       
  
• A four-way micro terminal block for providing specific power supplies and voltage references to the microcontroller       
  
• A jumper to select the power supply source (USB bus or barrel connector)       
  
• A power on/off switch
  

3. A built-in “microDART INTERFACE” section (with the main circuitry mounted on the back of the board) which allows the host PC to communicate with the microcontroller through a standard USB interface. Jumpers are present to configure this module. Thanks to the microDART in-circuit debugging firmware, BDM commands are sent to the target microcontroller through the USB bus. Additionally, a virtual COM port is automatically available over the same USB connection. This virtual COM port can be used by standard terminal programs, like HyperTerminal, to send/receive serial characters to/from the target microcontroller.4. An “I/O” section containing

       

• A Reset push-button       
  
• Four additional push-button       
  
• One potentiometer       
  
• Eight dip-switches       
  
• A piezoelectric buzzer       
  
• A light sensor       
  
• A temperature sensor       
  
• Ten user LEDs       
  
• A circuitry for driving and external LCD       
  
• A series of jumpers to connect/disconnect the above controls to/from the microcontroller
  

5. An “RS-232” section containing two RS-232 connectors together with a jumper to enable the RS-232 communication6. A “SERIAL SETTINGS” section containing jumpers to select communication optionsKit Contains

       

• The EVBQE128 evaluation board;       
  
• 80-pin LQFP MC9S08QE128 and MCF51QE128 microcontrollers;       
  
• A USB cable;       
  
• A pick-up vacuum pump;       
  
• A universal, 12 V DC power supply;       
  
• System software DVD-ROM, including CodeWarrior? Development Studio;       
  
• A Quick Start Guide sheet.
  

下载连接:
QE 系列评估板用户手册
QE 系列评估板快速入门指南